Product Description

Where to use

• Use on wood (Except Oak, Chestnut, Parquet and Veneer), metals (except Aluminum), plastic, stone, cement …
• Ideal for difficult to strip surfaces such as ornate, horizontal and vertical – doors, gates, stone etc.
• Recommended for stripping large areas – non-flammable, does not dry out, remains active a long time.
• Does not attack plastics, rubber, synthetic coating or fibreglass gel coats (GRP boats etc).

Recommendations for use

• Always test a small area first.
• Wear protective gloves – rubber, nitrile. Use nylon/synthetic brushes.
• Working time for stripping the finish varies from minutes to hours depending on the type of finish being removed (oil-based or water-based) and number of coats. Check the stripping action from time to time to establish when full removal of the finish(s) can be performed.
• Always neutralise surface with Net-trol (diluted 4:1) after stripping.

Directions for use

• Apply a thick layer of Dilunett to surface to be stripped.
• Allow to stand.
• If the Dilunett paint remover starts to dry, apply a fine mist of water to keep active.
• Scrub surface with stiff nylon brush and rinse with water using the highest pressure source available or use a pressure washer (max. 60 bar / 870 psi & not too close to the wood).
• Using hot water makes stripping the paint easier.
• After stripping wood, always neutralise with Net-trol, diluted 4:1 with water immediately after rinsing the Dilunett.
• Refer to packaging for full instructions.

Coverage : 4 m²/l

Application tools : Brush - Stiff bristle

Application temperature : 5°C to +35°C

Working time : 5 min. to 12 h.

Clean-up : Water